when gauge matters

Basically I’ve always lived on the edge when it comes to my knitting. I don’t do gauge swatches. I don’t worry too much about matching up my yarns. I don’t do a whole lot of counting and calculating. So far there haven’t been too many circumstances where this has come back to bite me in the ass, but last week, it did.

The funny thing is that it was and wasn’t my fault. I knit two fingerless mittens using the same needles and diligently counted the rows. When I was done, one was little and the other was big. I counted and recounted, but I had the same number of stitches. Waaah!? The gauge was off, but it wasn’t simply a tension issue. The yarn had actually increased in size! And here is where it was my fault. I spun that yarn. It was a navajo-plied yarn, so if the single had gotten thicker as I went, the ply would have gotten thicker and thicker too. Looking at the two mitts, I knew I couldn’t block them to match, so I knit another mitt. With barely enough yarn, I managed to complete a third mitt. It was just slightly larger than the second. Aarrrrg! Thankfully, the difference is minimal and I should be able to block them to match.

Here they are: my Papa Bear, Mama Bear, and Baby Bear mitts!

gauge issues